PM4/8/12/16 & PM4/8-SA Installation and User Guide v1.0
15
Paging all zones
1. Press and hold the CALL ALL button; all the LEDs for enabled zones and the
BUSY LED will illuminate.
2. Make the announcement.
3. Zones may be selected/deselected during the announcement.
4. When the announcement is nished, release the CALL ALL button.
Paging a Zone Group
1. Press the GROUP button for the required zone group. (The zone LEDs
corresponding to the zones dened for the group will illuminate.)
2. Press and hold down the TALK button.
3. Make the announcement.
4. Zones may be added/removed during the announcement. (NOTE - this is only
“per-announcement”; it does not alter the group denition).
5. Release the TALK button.
Announcement Interruption (Multiple PM systems only)
If the system has more than one PM microphone, it is possible that announcements
may be attempted from different microphones simultaneously. Priority assignments
made during the system installation can prevent two microphones on the network
from making an announcement at the same time. You may therefore nd that your
announcement is temporarily overridden by another announcement, from a PM with
higher priority.
If your announcement conicts with one from a higher priority microphone, yours will
be cut off and the interrupting announcement will take over. The interrupted PM will
indicate this condition by the ZONE LEDs ashing. The selection LEDs will remain lit
so that you can make your announcement again once the system is free.
Comments to this Manuals